I know Group 2,4,6 & 8 corellate to Buttons 1,2,3,4 but does group association affect the Topology and therefore lag? Ideally I want the Wallmotes to communicate directly to the switches, I thought that was the whole point of the Z-wave to make a mesh network and route the commands through other devices quickly. The group associations is really confusing, I'm really unsure as to how these should be selected/setup to help me do what I am aiming.I've tried to 'Heal' the network but this has not fixed anything.
(I have attached an image of my Topology - Screenshot-IMGUR) There is a lot of red, I feel this may be why there is so much lag.
My topology looks very wrong, I have moved icons around to visually represent our meeting room.I have selected 'Mirrors' on Wallmote 1 and selected Wallmote 2 & 3 however it does not appear to be mirroring the config to these devices.For example If I press button 1 to turn all 12 switches on I might get 5 turn on after about 30 seconds but then a minute later the rest slowly turn on over maybe 15 seconds - just really strange. Sometimes when a button is pressed there is lag between the switches as well.For instance I have just touched button 3 and it has taken 2 minutes for the lights to turn on and it takes the same amount of time for them to turn off. The first Wallmote I have setup has a massive lag time between touching Button 1 and all the lights coming on.I've managed to set the scenes up in AxialServer no worries.My aim: Is to initially configure one Wallmote and then mirror the config to the other 2 Wallmotes (we need 3 Wallmotes all acting the same as the room is a huge meeting room with multiple entrances/exits):
I then setup 30 second polling on each device and enabled Smart Route Polls. I have sucessfuly paired all the devices to the Z-Stick, identified them all and renamed them in Axial.
Aeon labs z stick gen5 usbport sticky Pc#
The PC has an Aeotec Z-Stick Gen5 (ZW090), all the lights are connected to Aeotec Smart Switch 6 (ZW096) and I have x3 Aeotec Quad Wallmote's (ZW130). I have a control PC (Win10 圆4) with AxialServer. I have a meeting room with 3 banks of LED lights, 4 lights in each row so a total of 12.
Aeon labs z stick gen5 usbport sticky pro#
I'm trially the Pro Edition of Axial Server to try and setup a Z-Wave network to control some lights in a fairly basic fashion.